Pro 80 New Masonry Cleaner
Product Overview
Pro 80 New Masonry Cleaner is a buffered formulation designed for cleaning masonry structures. It is especially effective in removing unwanted post-construction mortar residue from brick, tile, block, stone, precast, grout, and concrete brick.This product is suitable for use on most rough, unpolished masonry surfaces. Simply spray and rinse—no scrubbing required. This increases production per square foot, reduces labor costs, and minimizes brick saturation, helping to prevent efflorescence. As a buffered acidic detergent, Pro80 produces minimal fuming, though it does have a strong odor. When used as directed, it will not damage glass or anodized window frames.
Directions for Use
Dilution
Pressure washer (downstream): Mix 1 part Pro80 to 4 parts water.
Pump sprayer: Mix 12 ounces of Pro80 per 1 gallon of water.
In hard water areas, additional product may be required.
Surface Preparation
Pre-wet surfaces thoroughly before application. This ensures the cleaner works on dirt and mortar residue rather than being absorbed into a dry, porous surface.
Always test in an inconspicuous area first.
Application
When using a pressure washer, set the metering valve at the desired dilution.
Apply solution from the bottom up on a dry surface.
Rinse thoroughly from the top down.
Precautions & Safety Notes
Do not run this product through pumping systems or heating coils.
Do not use on:
Glass
Anodized or polished aluminum
Delicate paint
Surface-dyed substrates
Do not allow the product to dry on surfaces.
Always rinse thoroughly after use.
Use only on approved masonry surfaces as directed.
Protect plants, plumbing, wood surfaces, and elevator door finishes—cover if necessary.
For synthetic stone and surface-dyed substrates, use a low-pressure rinse only.
Do not brush surface-dyed substrates.

























